Configuring a Site-to-Site VPN using the VPN Wizard

You use the VPN Policy Wizard to create the site-to-site VPN policy.

Using the VPN Wizard to Configure Preshared Secret

1	Click the Wizard button on the top-right corner of the SonicOS management interface. In the Welcome screen, select the VPN Policy Wizard and then click Next.

2	In the VPN Policy Type page, select Site-to-Site and click Next.

3	In the Create Site-to-Site Policy page, enter the following information:

•	Policy Name: Enter a name you can use to refer to the policy. For example, Boston Office.

•	Preshared Key: Enter a character string to use to authenticate traffic during IKE Phase 1 negotiation. You can use the default SonicWALL generated Preshared Key.

•	I know my Remote Peer IP Address (or FQDN): If you check this option, this SonicWALL can initiate the contact with the named remote peer.

•	If you do not check this option, the peer must initiate contact to create a VPN tunnel. This device will use aggressive mode for IKE negotiation.

•	For this example, leave the option cleared.

•	Remote Peer IP Address (or FQDN): If you checked the option above, enter the IP address or Fully Qualified Domain Name (FQDN) of the remote peer (For example, boston.yourcompany.com).

4	Click Next.

5	In the Network Selection page, select the local and destination resources this VPN will be connecting:

•	Local Networks: Select the local network resources protected by this SonicWALL that you are connecting with this VPN. You can select any address object or group on the device, including networks, subnets, individual servers, and interface IP addresses.

•	If the object or group you want has not been created yet, select Create Object or Create Group. Create the new object or group in the dialog box that pops up. Then select the new object or group. For this example, select LAN Subnets.

•	Destination Networks: Select the network resources on the destination end of the VPN Tunnel. If the object or group does not exist, select Create new Address Object or Create new Address Group. For example:

a	Select Create new Address Group.

b	In the Name field, enter “LAN Group”.

c	In the list on the left, select LAN Subnets and click the -> button.

d	Click OK to create the group and return to the Network Selection page.

e	In the Destination Networks field, select the newly created group.

6	Click Next.

7	In the IKE Security Settings page, select the security settings for IKE Phase 2 negotiations and for the VPN tunnel. You can use the default settings.

•	DH Group: The Diffie-Hellman (DH) group are the group of numbers used to create the key pair. Each subsequent group uses larger numbers to start with. You can choose Group 1, Group 2, Group 5, or Group 14. The VPN Uses this during IKE negotiation to create the key pair.

•

Encryption: This is the method for encrypting data through the VPN Tunnel. The methods are listed in order of security. DES is the least secure and the and takes the least amount of time to encrypt and decrypt. AES-256 is the most secure and takes the longest time to encrypt and decrypt. You can choose. DES, 3DES, AES-128, or AES-256. The VPN uses this for all data through the tunnel

•	Authentication: This is the hashing method used to authenticate the key, once it is exchanged during IKE negotiation. You can choose MD5 or SHA-1.

•	Life Time (seconds): This is the length of time the VPN tunnel stays open before needing to re-authenticate. The default is eight hours (28800).

8	The Configuration Summary page details the settings that will be pushed to the security appliance when you apply the configuration.

9	Click Accept to create the VPN.