PANEL_manSnmpView
SNMP (Simple Network Management Protocol) is a network protocol used over User Datagram Protocol (UDP) that allows network administrators to monitor the status of the SonicWALL SuperMassive and receive notification of critical events as they occur on the network. The SonicWALL SuperMassive supports SNMP v1/v2c and all relevant Management Information Base II (MIB) groups except egp and at. The SonicWALL SuperMassive replies to SNMP Get commands for MIBII via any interface and supports a custom SonicWALL MIB for generating trap messages. The custom SonicWALL MIB is available for download from the SonicWALL Web site and can be loaded into third-party SNMP management software such as HP Openview, Tivoli, or SNMPC.
To enable SNMP on the SonicWALL SuperMassive, log into the Management interface and click System, then Administration. Select the Enable SNMP checkbox, and then click Configure. The Configure SNMP window is displayed.
Step 1 Type the host name of the SonicWALL SuperMassive in the System Name field.
Step 2 Type the network administrator’s name in the System Contact field.
Step 3 Type an Email address, telephone number, or pager number in the System Location field.
Step 4 Type a name for a group or community of administrators who can view SNMP data in the Get Community Name field.
Step 5 Type a name for a group or community of administrators who can view SNMP traps in the Trap Community Name field.
Step 6 Type the IP address or host name of the SNMP management system receiving SNMP traps in the Host 1 through Host 4 fields. You must configure at least one IP address or host name, but up to four addresses or host names can be used.
Step 7 Click OK.
Configuring Log/Log Settings for SNMP
Trap messages are generated only for the alert message categories normally sent by the SonicWALL SuperMassive. For example, attacks, system errors, or blocked Web sites generate trap messages. If none of the categories are selected on the Log > Settings page, then no trap messages are generated.
Configuring SNMP as a Service and Adding Rules
By default, SNMP is disabled on the SonicWALL SuperMassive. To enable SNMP you must first enable SNMP on the System > Administration page, and then enable it for individual interfaces. To do this, go to the Network > Interfaces page and click on the Configure button for the interface you want to enable SNMP on.
For instructions on adding services and rules to the SonicWALL SuperMassive, see Part five Firewall.
If your SNMP management system supports discovery, the SonicWALL SuperMassive agent automatically discover the SonicWALL SuperMassive on the network. Otherwise, you must add the SonicWALL SuperMassive to the list of SNMP-managed devices on the SNMP management system.